Independent Research Confirms Highcon’s Non-Crush Creasing Delivers Stronger Boxes than Analog Die Cutting and Saves Manufacturing Costs and Trees

blank
blank

Yavne, 29 June 2022 – A peer reviewed scientific research paper published on June 25th in Sensors, an MDPI journal, found categorically that when compared to conventional creasing performed by flatbed analog die cutting, Highcon’s patented DART creasing technology better preserves the inherent mechanical properties of corrugated boards while sustaining high packaging quality.

The first-of-its-kind study examined the impact of analog and digital creasing lines on the performance of corrugated cardboard and finished boxes, conducted by researchers from the Institute of Structural Analysis, Poznan University of Technology and the Department of Biosystems Engineering, Poznan University of Life Sciences.

Researchers measured a broad range of parameters on boards creased by both an analog die cutter and a Highcon digital die cutting system. Measurements were made on areas of the board that were both creased and uncreased, as well as on complete boxes.

Key findings included:

  • Less Substrate Damage and Increased Repeatability – Highcon’s digital technology is repeatable and causes considerably less damage to the structure of corrugated board than analog technology
  • Increased Compression Strength – Digital crease lines reduce the compression strength of the box to a lesser extent than analog crease lines
  • Increased Box Strength – Digital crease lines are stronger compared to analog. Digital technology does not crush the corrugated board, enabling higher load bearing capability
  • Increased Sustainability – Highcon enables lighter weight corrugated board to be used, saving substrate. It was found that the Highcon digitally creased box with 10% lower grammage was stronger than the analog creased box which imply a potential saving i paper board of at least 10% without compromising o box strength.

Dvir Harmelech, VP R&D and Chief Technology Officer, Highcon comments: “In an era of rising costs, supply chain challenges and material shortages, we were delighted with the conclusion of the MDPI Journal report – it provides independent specialist confirmation for the benefits of our solution to help support these issues. More specifically, the ability to increase box strength, even with lighter boards, is key to unlocking important financial, operational, and environmental benefits. It not only helps producers of corrugated boxes to digitalize their production, but also to reduce the weight of their products and thus save more trees.”

The study can be found here

 

The Shear Stiffness Tests (SST) and Torsion Stiffness Tests (TST)                                       In this chart, published as part of the article, you can see percentage differences between results for crease-free region samples and samples perpendicular to the crease on a corrugated board. The first chart shows analog results with decreasing board strength, and the second shows Highcon digitally creased board.

Share Press Release post

More Press Releases

post-image
Highcon New Digital Die Cutting Solutions for Mainstream Production

More Info
post-image
Ingram Express Services Enhances Folding Carton Capabilities

More Info
post-image
Menasha Packaging Company Purchases Two Highcon Beam 2 Digital Die Cutting Systems

Highcon and Menasha have signed a LOI reflecting their intent to partner on the integration of new Highcon systems over the next 24 months.

More Info
Ir al contenido